User's Manual
Table Of Contents
- Table of Contents
- General Aspects
- About This Manual
- Features of Fluke 434-II/435-II/437-II
- Basic Operations and Menu Navigation
- Display Information
- Input Connections
- Scope Waveform and Phasor
- Volts/Amps/Hertz
- Dips & Swells
- Harmonics
- Power & Energy
- Energy Loss Calculator
- Power Inverter Efficiency
- Unbalance
- Inrush
- Monitor - Power Quality Monitoring
- Flicker
- Transients
- Power Wave
- Mains Signaling
- Logger
- Shipboard V/A/Hz
- Cursor and Zoom
- Setting up the Analyzer
- Using Memory and PC
- Tips and Maintenance
- Specifications
- Appendices
- Index
C-1
Appendix C
Instrument Security Procedures
Introduction
Model Numbers:
Fluke 434-II, Fluke 435-II, Fluke 437-II
Short Description:
3-Phase Energy & Power Quality Analyzer
Memory.
Fluke 43x-II has the following memory devices:
1. RAM 8M x 16, U901, type: e.g. MT47H64M16HR-25IT:H,
contains: temp storage of measuring data
2. Video RAM 256k x 16, D1001, type: e.g. CY62146EV30LL,
contains: storage of data to be displayed on LCD-screen.
3. Flash-ROM 16M x 2, U1100, U1101, type: e.g. MW29W160EB,
contains: the instrument’s embedded software and calibration data.
Also Analyzer settings such as Config, Freq, Vnom, Limits, and Current Clamp data
that differ from Factory Default are stored here.
4. FIFO (First In First Out) RAM 2kB, U801, type: e.g. SN74V235-7PAG,
contains: data to be exchanged between DSP and Microcontroller.
5. SRAM 16 Mb x 2, D1100, D1103, type: e.g. CY62167DV30LL,
contains: temporary data storage for microcontroller.
6. SD Memory Card. Contains: all datasets, screens, and logging data.