User's Manual
Table Of Contents
- Table of Contents
- General Aspects
- About This Manual
- Features of Fluke 434-II/435-II/437-II
- Basic Operations and Menu Navigation
- Display Information
- Input Connections
- Scope Waveform and Phasor
- Volts/Amps/Hertz
- Dips & Swells
- Harmonics
- Power & Energy
- Energy Loss Calculator
- Power Inverter Efficiency
- Unbalance
- Inrush
- Monitor - Power Quality Monitoring
- Flicker
- Transients
- Power Wave
- Mains Signaling
- Logger
- Shipboard V/A/Hz
- Cursor and Zoom
- Setting up the Analyzer
- Using Memory and PC
- Tips and Maintenance
- Specifications
- Appendices
- Index
Basic Operations and Menu Navigation
Reset to Factory Defaults 4
4-7
Reset to Factory Defaults
Proceed as follows to reset the Analyzer to factory default settings (initial setups, limits,
etc.):
Turn power off, then press and hold SAVE SCREEN and turn on again. You should hear
a double beep,
OR
Use submenu SETUP, USER PREF. as a starting point. How to get there is explained
above under Menu Navigation:
F1
Press to start the reset to default settings. Because of the risk
of unwanted erasure of data, a confirm menu pops up.
F5
Press to confirm the reset.