User's Manual
Table Of Contents
- Table of Contents
- General Aspects
- About This Manual
- Features of Fluke 434-II/435-II/437-II
- Basic Operations and Menu Navigation
- Display Information
- Input Connections
- Scope Waveform and Phasor
- Volts/Amps/Hertz
- Dips & Swells
- Harmonics
- Power & Energy
- Energy Loss Calculator
- Power Inverter Efficiency
- Unbalance
- Inrush
- Monitor - Power Quality Monitoring
- Flicker
- Transients
- Power Wave
- Mains Signaling
- Logger
- Shipboard V/A/Hz
- Cursor and Zoom
- Setting up the Analyzer
- Using Memory and PC
- Tips and Maintenance
- Specifications
- Appendices
- Index
i
Table of Contents
Chapter Title Page
1 General Aspects .................................................................................. 1-1
Introduction........................................................................................................ 1-1
Limited Warranty & Limitation of Liability...................................................... 1-2
Shipment Note ................................................................................................... 1-3
Contacting a Service Center............................................................................... 1-4
Safety Information: Read First........................................................................... 1-4
Safe Use of Li-ion Battery Pack ........................................................................ 1-7
2 About This Manual .............................................................................. 2-1
Introduction........................................................................................................ 2-1
Users Manual Contents...................................................................................... 2-1
3 Features of Fluke 434-II/435-II/437-II .................................................. 3-1
Introduction........................................................................................................ 3-1
General Measurements ...................................................................................... 3-1
Measuring modes to investigate details ............................................................. 3-2
Logging of Measuring Values in Meter Screens ............................................... 3-3
4 Basic Operations and Menu Navigation............................................ 4-1
Introduction........................................................................................................ 4-1
Tilt Stand and Hang Strap.................................................................................. 4-2
Powering the Analyzer....................................................................................... 4-3
Installation and Replacement of a Battery Pack ................................................ 4-4
SD Memory Card............................................................................................... 4-5
Initial Setup........................................................................................................ 4-5
Display Brightness............................................................................................. 4-6
Locking the keyboard ........................................................................................ 4-6
Menu Navigation ............................................................................................... 4-6
Display Contrast ................................................................................................ 4-6
Reset to Factory Defaults................................................................................... 4-7
5 Display Information............................................................................. 5-1
Introduction........................................................................................................ 5-1