User's Manual

Manual Supplement



Manual Title: Fluke 434-II/435-II/437-II Service Supplement Issue: 2

Part Number: 4822 872 05408 Issue Date: 1/15

Print Date: February 2013 Page Count: 1

Revision/Date:

This supplement contains information necessary to ensure the accuracy of

the above manual.

PAGE 1
Manual Supplement Manual Title: Fluke 434-II/435-II/437-II Service Supplement Issue: 2 Part Number: 4822 872 05408 Issue Date: 1/15 Print Date: February 2013 Page Count: 1 Revision/Date: This supplement contains information necessary to ensure the accuracy of the above manual. © 2014-2015 Fluke Corporation. All rights reserved.
PAGE 2
Fluke 434-II/435-II/437-II Service Manual Supplement Change #1 On page 4-6, add a note after step 5: Note If the display readings are all dashes, it is likely in HOLD. Check the status in the lowerright corner of the display. If in HOLD, push F5. The F5 display changes to NOW. Push F5 again for RUN status. Voltage and current readings should now be shown. Change #2, 102 On page 4-7, replace step 5 with: 5. Press . Then press F4 – MANUAL SETUP.