Product Manual

Before You Start

Set-Up

1-27

Lens Replacement

Only replace the lenses in dry and low-dust conditions.

When the lens is removed, the degree of protection

IP 54

of the system is no longer guaranteed!

Position the thermal imager on a solid, level plane so that

the lens is pointed towards you. Rotate the lens on the

thermography system counterclockwise as far as it will go

and/or until the two red dots are aligned. Then, remove

the lens to the front.

In order to attach the lens, the red marking spots on lens

and camera must be aligned. In this position, the lens

must be pressed slightly against the camera corpus and

turned clockwise until the red dot of the lens is aligned

with the white dot of the camera.

Operation using the Gigabit Ethernet (GigE)

Interface

Please proceed as follows in order to connect the thermal

imager to a PC/notebook. The accessories described are

contained in the scope of delivery as an option.

• The Ethernet cable is used in order to establish a

connection to the Ethernet interface of the PC (RJ45

connector).

• The 8-pin LEMO connector (blue mark) is connected

to the left 8-pin LEMO socket (Figure 1-2, blue mark)

on the camera.

 Caution

Make sure you establish the connection to

the correct LEMO socket. Plug the LEMO

connector into the socket with the red dot

directed to the top. Do not force the

connector in.