User manual

ManualsBrandsFLUKE ManualsTest Leads & ProbesSafety test probe set 4 mm socket CAT III 1000 V, CAT IV 600 V Black MP1-MAGNET PROBE 1

PN 4584021

September 2015

Specifications are subject to change without notice.

All product names are trademarks of their respective companies.

MP1

Magnet Probe

Instruction Sheet

Introduction

The MP1 Magnet Probe (the Probe or Product) is an accessory with a

magnetic tip for 4 mm safety test leads. The magnetic tip provides

contact to a ferromagnetic metal surface in areas with limited access

such as the carbon steel screws on RCDs or circuit breakers.

The probe fits into recessed screw holes with a diameter of ≥6 mm.

The probe is CAT IV 600 V/CAT III 1000 V rated with a maximum

current of 4 A.

fig_MP1.eps

Summary of content (5 pages)

PAGE 1
MP1 Magnet Probe Instruction Sheet Introduction The MP1 Magnet Probe (the Probe or Product) is an accessory with a magnetic tip for 4 mm safety test leads. The magnetic tip provides contact to a ferromagnetic metal surface in areas with limited access such as the carbon steel screws on RCDs or circuit breakers. The probe fits into recessed screw holes with a diameter of ≥6 mm. The probe is CAT IV 600 V/CAT III 1000 V rated with a maximum current of 4 A. fig_MP1.
PAGE 2
Contacting Fluke To contact Fluke, call one of the following telephone numbers: • Technical Support USA: 1-800-44-FLUKE (1-800-443-5853) • Calibration/Repair USA: 1-888-99-FLUKE (1-888-993-5853) • Canada: 1-800-36-FLUKE (1-800-363-5853) • Europe: +31 402-675-200 • Japan: +81-3-6714-3114 • Singapore: +65-6799-5566 • Anywhere in the world: +1-425-446-5500 Or, visit Fluke's website at www.fluke.com. To register your product, visit http://register.fluke.com.
PAGE 3
• Do not exceed the Measurement Category (CAT) rating of the lowest rated individual component of a Product, probe, or accessory. • Do not use the Product if it is damaged. • Do not expose the Product to temperatures ≥80°C (176°F). High temperatures cause permanent damage to the magnet. • Make sure the magnetic force is strong enough to keep the Product in place. The Product works only on ferromagnetic material.
PAGE 4
Instructions The Product has optimum holding strength with M5 pan-head screws. It also can be used to contact any screw head or metal contact that has magnetic attraction, such as carbon steel alloys. Do not use with metal contacts that do not have magnetic attraction. For example, copper alloy contacts, aluminum alloy contacts, and most stainless steel alloy contacts are not suitable for use with this Product.
PAGE 5
Specifications Maximum Current ........................... 4 A Maximum Voltage between Terminal and Earth Ground ............ 1000 V Safety ............................................. IEC61010-031: CAT IV 600 V/CAT III 1000 V, Pollution Degree 2 Temperature Operating ............................... -10 °C to +50 °C (14 °F to 122 °F) Storage ................................... -20 °C to +60 °C (-4 °F to +140 °F) Operating Humidity.........................