User's Manual

572-2

Users Manual

Maintenance

Battery Charge

Use the battery charge symbols to gauge the approximate level of charge left on the

batteries.

Note

When in low battery mode, the Product does not store values.

“Err” shows on the display if attempted.



Batteries are at 5 %. Before taking further

readings, the batteries must be changed.

Battery Replacement

Warning

To prevent possible electrical shock, fire, eye damage, and

personal injury:

• Do not open the Product. The laser beam is dangerous

to eyes. Have the Product repaired only through an

approved technical site.

• Have an approved technician repair the Product.

For safe operation and maintenance of the Product:

• Repair the Product before use if the batteries leak.

• Be sure that the battery polarity is correct to prevent

battery leakage.

Caution

• Do not short the battery terminals together.

• Do not keep cells or batteries in a container where the

terminals can be shorted.

• Do not put battery cells and battery packs near heat or

fire. Do not put in sunlight.

Note

The batteries should be replaced in less than one minute after

removal to avoid manually re-initializing the Product clock and

date.

To install or change the two AA batteries (see Figure 8):

1. Slide the locking tab on the battery door to the “” position and then open the

handle.

2. Insert the batteries noting their correct polarity.

3. Close and lock the handle.