User's Manual

ManualsBrandsFluke ManualsCalibratorsFluke 718

Supplement

Title: 714 Inst.Sht. Supplement Issue: 4

Part Number: 650306 Issue Date: 1/14

Print Date: July 1997 Page Count: 4

Revision/Date: 1, 10/97

This supplement contains information necessary to

ensure the accuracy of the document described

above.

Summary of content (5 pages)

PAGE 1
Supplement Title: 714 Inst.Sht. Supplement Issue: 4 Part Number: 650306 Issue Date: 1/14 Print Date: July 1997 Page Count: 4 Revision/Date: 1, 10/97 This supplement contains information necessary to ensure the accuracy of the document described above. © 2005-2014 Fluke Corporation. All rights reserved..
PAGE 2
714 Instruction Sheet Supplement Change #1 In the Thermocouple Properties table, change the R, S, and B Display Resolution: From: 1°C or °F To: 0.1°C or °F Following Turning the Calibrator On, add the following sections: Auto Shut-Off (Power Saver) The Calibrator automatically turns off after 30 minutes of inactivity. To reduce the time or disable this feature: 1. With the Calibrator OFF, press . P.S.xx is displayed, where xx is the turn-off time in minutes. OFF means the power saver is disabled. 2.
PAGE 3
Supplement 2. 3. 4. 714 Instruction Sheet Press  and  simultaneously to store the 0% value. Use  or  and/or  or  to set the output to the desired value for 100%. Press  and  simultaneously to store the 100% value. Disable Cold Junction Compensation (CJC) It is possible to disable CJC by turning the 714 off, then turning it on again while depressing the . The LCD will display CJC OFF to indicate CJC is disabled. CJC will default to enabled when power is applied.
PAGE 4
714 Instruction Sheet Supplement Temperature Measure and Thermocouple Simulate TC Type Range C Accuracy C * J -210.0 to 0.0 0.6 0.0 to 800.0 0.4 800.0 to 1200.0 0.5 K -200.0 to 0.0 0.8 0.0 to 1000.0 0.5 1000.0 to 1372.0 0.7 T -250.0 to 0.0 0.8 0.0 to 400.0 0.4 E -250.0 to -100.0 0.8 -100.0 to 1000.0 0.4 R -20.0 to 0.0 2.0 0.0 to 1767.0 1.4 S -20.0 to 0.0 2.0 0.0 to 1767.0 1.4 B 600.0 to 800.0 1.4 800.0 to 1000.0 1.5 1000.0 to 1820.0 1.7 L -200.0 to 0.0 0.45 0.0 to 900.0 0.4 U -200.0 to 0.0 0.7 0.
PAGE 5
Supplement 714 Instruction Sheet Change #2 Under General Specifications, add the following: Protection Class: Pollution Degree II Change #3 On the third panel, under International Symbols, add the following:  Conforms to Australian C-Tick directives Change #4, 67382 On the third panel, under International Symbols, add:  Conforms to relevant South Korean EMC Standards. Under General Specifications, add: Electromagnetic Compatibility ......Applies to use in Korea only.