User's Manual

DPC/TRACK
Users Manual
B-4
Performing a Test on the Calibrator
To aid in the discussion of performing our test, we have provided a diagram of the
front of the Fluke 743 Documenting Calibrator (Figure B-2). You should refer to
this diagram as necessary when instructed to push a particular button while
performing the test.
Enter Key
Soft Key 4
Soft Key 3
Power Key
Arrow Keys
TC
mA mA
VV
RTD
RTD
SOURCE
300V
MAX
30V
MAX
30V
MAX
30V
MAX
MEAS
CAT
MEAS
SOURCE
SETUP
mA
V
V
Hz
TC
RTD
789
456
123
0
.
ENTER
CLEAR
(ZERO)
RANGE
Soft Key 1
Soft Key 2
ED003F.EPS
Figure B-2. 743 Calibrator
A sketch of the bottom portion of the calibrator, where jumper wires will be
attached to perform our test, is shown in Figure B-3. The documentation that
accompanied your calibrator includes diagrams for other types of tests.
The test we will perform is of the “Measure Source” variety. Basically, we are
going to have the calibrator test a pair of wires.