User's Manual

Fluke Calibrators
Fluke Calibrator Diagnostics B
B-7
Fluke Calibrator Diagnostics
Note
These instructions apply to both the 702 and the 743 calibrators.
Before running diagnostics, be sure to attach your calibrator to the appropriate
communications port and turn it on. (This port is specified in your
DPCTRACK.INI
file by the ComPort variable.)
1. Select the System Setup button.
2. Select the Calibrator Diag... button.
3. DPC/Track does the following:
• confirms that the files responsible for communications are present and
of the right revision
• attempts to establish communications with the attached calibrator
If communications are properly established...
A message appears informing you of this, press OK to return to the System
Setup screen.
If communications are not properly established...
If you receive an error message, press OK to return to the System Setup screen.
Check your connections and try again. If you continue to experience problems, try
a different calibrator.
You may need to contact Fluke
for support.