User's Manual

Installation
3
As the installation progresses, the status bar dynamically indicates the installation
progress of the entire installation procedure.
4. You can now start your DPC/TRACK program. Go directly to the online help by
clicking on the help icon.
Note
If for any reason your computer “freezes” during the installation of the
DPC/TRACK you will need to remove the following files:
• Windows Directory: _delis43.ini
• Tmp directory: _ins0433.mp, _inz0433.mp and subdirectory:
_istmp0.dir
• DPC/TRACK directory and all subdirectories.
Repeat the installation procedure.
Floppy Disk Installation Instructions
Floppy disks are available only on a special order basis.
Note
The instructions below assume your floppy drive to be the A: drive.
Substitute your drive letter as appropriate.
1. Insert Disk 1 of the desired language (English, French, German, Italian, or Spanish)
into the floppy drive and perform either of the following, depending on the platform
you are running:
• If you are running Windows 3.1 or later:
Type A:SETUP within the
Command Line
prompt box accessed via the
Run
command on the
File
menu within Windows Program Manager.
(Select the
OK
button to activate your command.)
• If you are running Windows 95:
Select the
Start
button, then choose
Run...
, then type A:SETUP.
(Select the
OK
button to activate your command.)
2. You will be asked to specify which directory will hold the DPC/TRACK executable
files. The default directory will be C:\DPCTRACK. You may accept the default or
specify a different directory. A subdirectory called DATA (to contain your database
files) is created under the specified executable directory. Another subdirectory called
UPGRADES (to contain firmware upgrades for specific calibrators) is also created.