User's Manual

ManualsBrandsFluke ManualsClamp MetersFluke 902

Supplement

Title: 902 Users Supplement Issue: 3

Part Number: 2547887, 2840080

Print Date: May 2006 Issue Date: 8/13

Revision/Date: 1, 3/07 Page Count: 4

This supplement contains information necessary to

ensure the accuracy of the above Instruction Sheet.

Summary of content (5 pages)

PAGE 1
Supplement Title: 902 Users Supplement Issue: 3 Part Number: 2547887, 2840080 Print Date: May 2006 Issue Date: 8/13 Revision/Date: 1, 3/07 Page Count: 4 This supplement contains information necessary to ensure the accuracy of the above Instruction Sheet. © 2006 -2013 Fluke Corporation. All rights reserved. Printed in the China.
PAGE 2
902 Users Manual Supplement Change #1 On page 23, under Electrical Specifications, replace the Temperature row with the following: Temperature -40 to 400 ºC 0.1 ºC -40 to -10 ºC ±5.0 % + 1.5 ºC typical -10 to 400 ºC ±1.0 % + 0.8 ºC typical Change #2 On page 3, under Read First: Safety Information, replace the 4th bullet with the following:  Never use the Meter on a circuit with voltages higher than 600 V or a frequency higher than 60 Hz fundamental. The Meter may be damaged.
PAGE 3
Manual Supplement 902 Users On page 11, replace the first bullet with the following:  If the resistance is < 30 , the continuity beeper will sound. On page 20, under Maintenance, add the following note: Note When the Meter displays CAL, the unit will lock and no measurements can be made. The Meter must be sent to a Fluke Service Center for repair. Change #3 On page 4, add:  Measure a known voltage to verify product operation.
PAGE 4
902 Users Manual Supplement CAT III Measurement Category III is applicable to test and measuring circuits connected to the distribution part of the building’s low-voltage MAINS installation. CAT IV Measurement Category IV is applicable to test and measuring circuits connected at the source of the building’s low-voltage MAINS installation.  Conforms to CAN/CSA-C22.2 No. 61010-1, second edition, including Amendment 1.  Conforms to relevant South Korean EMC Standards.
PAGE 5
Manual Supplement 902 Users Electromagnetic Compatibility Applies to use in Korea only. Class A Equipment (Industrial Broadcasting & Communication Equipment) [1] [1] This product meets requirements for industrial (Class A) electromagnetic wave equipment and the seller or user should take notice of it. This equipment is intended for use in business environments and is not to be used in homes.