User's Manual

AirMeter
TM
Test Tool
Min Max Avg
15
Min Max Avg
The Min Max mode stores minimum (MIN) and maximum
(MAX) input values. When the input drops below the
stored minimum value or above the stored maximum
value, the Meter beeps and stores the new value. Min
Max mode also calculates an average (AVG) of all
readings taken since the mode was activated.
Min Max mode works with Temperature, CO, CO
2
,
Relative Humidity, Dew Point, Wet Bulb, and Air Velocity.
To use Min Max mode, press . The maximum
reading appears first. Each subsequent press of

steps through the minimum, average, and live readings,
and back to the maximum reading.
To deactivate Min Max mode, hold
 for
approximately two seconds.
Data Logging
The Meter logs discrete (single-point) or continuous data.
Data logs are viewed on the Meter or can be uploaded to
a PC running FlukeView

Forms software. Refer to
“Transferring Data to a Personal Computer” for more
information.
Saving Single-Point Data
The Meter is able to save single-point data logs in non-
volatile flash memory.
Single-point data logs list measured parameters,
calculated duct volume flow rates, or % outside air.
Single-point logs include:
• Sample ID (1-99)
• Temperature
• Relative Humidity
• Wet Bulb
• Dew Point
• CO
• CO
2
• Time/date stamp
Velocity, duct volume flow rate and % outside air logs
include:
• Sample ID (1-99)
• Time/date stamp
• Velocity (actual or standard) or calculated duct
volume flow rate, or % outside air calculation results