Operation Manual

DSP-4000 Series
Users Manual
2-30
Select a frequency for the power line noise filter.
Set the fault threshold for the impulse noise test.
Enable or disable the test tools beeper.
Modify test standards for custom test configurations.
Select a remote end configuration when a Fiber Test Adapter is attached.
Print
Allows you to send saved reports or report summaries to a serial printer. You can
print the results from previously stored Autotests. Also lets you edit the report
identification information and select a format for Autotest reports sent directly to a
printer.
Special Functions
Allows you to do the following:
View or delete test reports saved in memory.
Change the cable identification assigned to a saved Autotest report.
Generate a tone to use with an inductive pickup device, such as the Fluke
Networks 140 A-Bug Tone Probe, to identify cabling runs.
Determine the cable NVP to ensure maximum accuracy of length results.
View the status of the NiMH battery in the main unit or remote.
Check the status of the LIA attached to the main or remote unit.
Perform a self-calibration on the test tool and remote.
Run a self-test to verify proper operation of the test tool, link interface adapter,
and remote.
On DSP-4100 and DSP-4300 test tools, you can view the status of the memory
card and format the card.
View version information for the main and remote units.