User Guide

FLK-TI-SBC3
Charging Base/Power Supply with Adapters
Instruction Sheet
The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a
charging base, power supply, and power outlet adapters.
PN 3481481 August 2009
© 2009 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies. Specications are subject to change without notice.
Safety Information
Use the FLK-TI-SBC3 only as specied in this instruction sheet or other Fluke
product-specic manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.
A Warning identies hazardous conditions and actions that could cause bodily harm or
death.
A Caution identies conditions and actions that could damage the Imager or cause
permanent loss of data.
W Warning
To avoid injury:
Do not disassemble or short circuit the battery pack. ●
Do not expose the battery pack to temperatures above 50 °C (122 °F). ●
Do not incinerate or mutilate the battery pack. ●
Use only ac adapters approved by Fluke for the product to charge the battery or ●
power the product.
Table 1. Symbols
Symbol Description
P
Conforms to requirements of European Union and European Free Trade Association.
"
Imager connected to battery charger.
;
Conforms to relevant Australian standards.
)
Conforms to relevant Canadian and US standards
W
Important information. See manual.
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
recycling information.
Charging the Battery
Before using the battery pack for the rst time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the “Ti32,
TiR32 Thermal Imagers User Manual.”
Specications
See Table 2 for the specications.
Table 2. Specications
Battery Charging
10-15 Vdc 2 A or charge battery pack in Imager with included ac
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
Charging / Power LED
Status Charging LED Power LED
off no battery detected no dc power input
solid green charged dc power present
blinking green charging na
blinking red fault na
Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature -10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature -20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range 10 % to 95 % non-condensing
POWER
Ti SBC3
SMART BATTERY
CHARGER 3