User Manual

True-rms Digital Multimeter

Maintenance

Replace the batteries as follows, refer to Figure 11:

1. Turn the rotary switch to OFF and remove the test

leads from the terminals.

2. Remove the six Torx-head screws from the case

bottom and remove the battery door ().

Note

When you lift the battery door, make sure the

rubber gasket stays attached to the battery

compartment barrier.

3. Remove the three batteries and replace all three with

AAA Alkaline batteries ().

4. Make sure the battery compartment gasket () is

properly installed around the outside edge of the

battery compartment barrier.

5. Align the battery compartment barrier with battery

compartment while you replace the battery door.

6. Attach the door with the six Torx-head screws.

Note

Fluke recommends that you remove the

batteries from the Product for long periods of

storage.