SDS

ManualsBrandsFluke ManualsCalibration MetersIntrinsically safe current loop calibrator, 24 mA, Current/Loop Calibrator/Voltage

707Ex

mA Calibrator

Safety Information

A Warning identifies conditions and actions that pose

hazard(s) to the user; a Caution identifies conditions and

actions that may damage the Calibrator or the equipment

under test.

Safety and electrical symbols used in this sheet and on

the Calibrator are displayed in Table 1.

Table 1. International Electrical Symbols

Symbol Meaning Symbol Meaning

Power ON/OFF

Double insulated

Earth ground

)

Conforms to relevant Canadian and US Standards.

Certification # LR110460-2

Risk of Danger. Important

information. Refer to manual.

Conforms to relevant European Union directives.

Battery F

Direct current

Hazardous Voltage

Conforms to Factory Mutual requirements

(

Conforms to ATEX requirements

;

Conforms to relevant Australian standards.

Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for recycling

information.

Summary of content (4 pages)

PAGE 1
707Ex mA Calibrator actions that may damage the Calibrator or the equipment under test. Safety and electrical symbols used in this sheet and on the Calibrator are displayed in Table 1. Safety Information A Warning identifies conditions and actions that pose hazard(s) to the user; a Caution identifies conditions and Table 1. International Electrical Symbols Symbol Meaning Symbol T Meaning + Power ON/OFF J Earth ground ) Conforms to relevant Canadian and US Standards.
PAGE 2
707Ex Safety Information Read the entire Users Manual and the 707Ex mA Calibrator CCD (Concept Control Drawing) before using the Calibrator. XWWarnings and Cautions To avoid electric shock, injury, or damage to the Calibrator: • Use the Calibrator only as described in this Users Manual and the Fluke 707Ex mA Calibrator CCD (Concept Control Drawing) or the protection provided by the Calibrator may be impaired. • Inspect the Calibrator before use. Do not use it if it appears damaged.
PAGE 3
mA Calibrator Safety Regulations • • • • • • • • • • External damage to the housing Internal damage to the Calibrator Exposure to excessive loads Incorrect storage of the unit Damage sustained in transit Correct certification is illegible Using the product with the red holster removed Functioning errors occur Permitted limitations are exceeded Functioning errors or obvious measurement inaccuracies occur which prevent further measurement by the Calibrator.
PAGE 4
707Ex Safety Information General Specifications Maximum voltage between any terminal and earth ground or between any two terminals: 28 V Storage temperature: − 30 °C to 60 °C Operating temperature: − 10 °C to 50 °C Relative humidity: 95 % up to 30 °C 75 % up to 40 °C 45 % up to 50 °C CE: Complies with EN61010-1 and EN61326 Contacting Fluke To contact Fluke, call one of the following telephone numbers: • Technical Support USA: 1-800-44-FLUKE (1-800443-5853) • Calibration/Repair USA: 1-888-99-FLUKE (1-88899