Datasheet
PN 4240668
January 2013
© 2013 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies.
709/709H
mA Loop Calibrator
Safety Information
Go to www.fluke.com to register your product and find more
information.
A Warning identifies conditions and procedures that are dangerous to
the user.
Warning
To prevent possible electrical shock, fire, or personal injury:
• Read all safety Information before you use the
Product.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Examine the case before you use the Product.
Look for cracks or missing plastic. Carefully look
at the insulation around the terminals.
• Do not use test leads if they are damaged.
Examine the test leads for damaged insulation
and measure a known voltage.
• Do not use and disable the Product if it is
damaged.
• Do not use the Product around explosive gas,
vapor, or in damp or wet environments.
• Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
• Do not apply more than the rated voltage,
between the terminals or between each terminal
and earth ground.
• Do not connect directly to mains.
• Do not exceed the Measurement Category (CAT)
rating of the lowest rated individual component of
a Product, probe, or accessory.
• Keep fingers behind the finger guards on the
probes.
• Remove all probes, test leads, and accessories
before the battery door is opened.