User Manual

ManualsBrandsFluke ManualsCalibration MetersPressure Calibrator 7 bar

Supplement

Title: 717 Inst.Sht. Supplement Issue: 3

Part Number: 690013 Issue Date: 1/14

Print Date: March 1998 Page Count: 4

Revision/Date: 2, 3/06

This supplement contains information necessary to

ensure the accuracy of the document described

above.

Summary of content (5 pages)

PAGE 1
Supplement Title: 717 Inst.Sht. Supplement Issue: 3 Part Number: 690013 Issue Date: 1/14 Print Date: March 1998 Page Count: 4 Revision/Date: 2, 3/06 This supplement contains information necessary to ensure the accuracy of the document described above. © 2008-2014 Fluke Corporation. All rights reserved.
PAGE 2
717 Instruction Sheet Supplement Change #1 On the second panel, under Symbols, add the following:  Conforms to relative Australian standards Change #2 59696, On the first panel, under “The 717 Pressure Calibrators (hereafter, “the Calibrator”) include” add the following:   717 15G 717 10000G On the second panel, under Input Units, add the following:  inH2O @ 60 F Under the Replacement Parts and Accessories, add the following to the Table: Item Parts or Accessory No.
PAGE 3
Supplement 717 Instruction.Sheet Under Specifications replace the entire section with the following: Specifications Specifications apply for ambient temperature from +18 ºC to +28 ºC unless stated otherwise. “Counts” are the number of increments or decrements of the least significant digit. Model 717 1G 717 15G 717 30G 717 100G 717 300G 717 500G 717 1000G 717 1500G 717 3000G Range Max -1 to 1 psi 5 psi -7 to 7 kPa 34.
PAGE 4
717 Instruction Sheet 717 5000G 717 10000G Supplement 0 to 20.7 mPa 41.4 mPa 0 to 5000 psi 10000 PSI 0 to 34.5 mPa 69 mPa 0 to 10000 psi 15000 psi 0 to 69 mPa 103.4 mPa 0.025 % 0.035 % 0.035 % 0.050 % [1] In an RF field of 1 V/m to 3 V/m between the frequencies of 1.4 GHz to 2.0 GHz, add 120 counts to specified accuracy. Change #3, 59844 In the Specification section, add the following: Specifications apply to the 717 Pressure Calibrators with firmware version 4.0 or greater.
PAGE 5
Supplement 717 Instruction.Sheet Change #4, 67386 On the second panel, under Symbols, add:  Conforms to relevant South Korean EMC Standards. Under General Specifications, add: Electromagnetic Compatibility ......Applies to use in Korea only. Class A Equipment (Industrial Broadcasting & Communication Equipment) [1] [1] This product meets requirements for industrial (Class A) electromagnetic wave equipment and the seller or user should take notice of it.