User Manual
Table Of Contents
- 724 Temperature Calibrator
- Temperature Calibrator
- Introduction
- Contacting Fluke
- Standard Equipment
- Safety Information
- Getting Acquainted with the Calibrator
- Getting Started
- Shut Down Mode
- Contrast Adjustment
- Using Measure Mode
- Using Source Mode
- Setting 0 % and 100 % Output Parameters
- Stepping and Ramping the Output
- Storing and Recalling Setups
- Calibrating a Transmitter
- Testing an Output Device
- Replacing the Batteries
- Replacing the Fuse
- Maintenance
- Specifications
- Index
Temperature Calibrator
Standard Equipment
3
Standard Equipment
The items listed below and shown in Figure 1 are included
with your calibrator. If the calibrator is damaged or
something is missing, contact the place of purchase
immediately. To order replacement parts or spares, see
the user-replaceable parts list in Table 7.
• TL75 test leads (one set)
• Alligator clips (one set)
• Stackable alligator clip test leads (one set)
• 724 Product Overview Manual
• 724 CD-ROM (contains Users Manual)
• Spare fuse
Safety Information
The calibrator is designed in accordance with IEC1010-1,
ANSI/ISA S82.01-1994 and CAN/CSA C22.2 No. 1010.1-
92. Use the calibrator only as specified in this manual,
otherwise the protection provided by the calibrator may be
impaired.
A Warning identifies conditions and actions that pose
hazard(s) to the user; a Caution identifies conditions and
actions that may damage the calibrator or the equipment
under test.
International symbols used on the calibrator and in this
manual are explained in Table 2.