User Manual
Table Of Contents
- 724 Temperature Calibrator
- Temperature Calibrator
- Introduction
- Contacting Fluke
- Standard Equipment
- Safety Information
- Getting Acquainted with the Calibrator
- Getting Started
- Shut Down Mode
- Contrast Adjustment
- Using Measure Mode
- Using Source Mode
- Setting 0 % and 100 % Output Parameters
- Stepping and Ramping the Output
- Storing and Recalling Setups
- Calibrating a Transmitter
- Testing an Output Device
- Replacing the Batteries
- Replacing the Fuse
- Maintenance
- Specifications
- Index
Temperature Calibrator
Getting Acquainted with the Calibrator
11
Table 4. Key Functions
No Name Description
A O Turns the power on or off.
B V Selects voltage measurement function in the upper display.
C A Selects the mA measurement function in the upper display.
D K Activates a 24-volt loop supply while measuring mA.
E C Turns backlight on or off. Turns contrast adjust mode on when powering up.
F F Displays temperature in degrees Celsius when in TC or RTD functions.
G D Displays temperature in degrees Fahrenheit when in TC or RTD functions.
H G Recalls from memory a source value corresponding to 100 % of span and sets it as the source value.
Press and hold to store any source value as the 100 % value.
I H Increments output by 25 % of span.
J I Decrements output by 25 % of span.
K J Recalls from memory a source value corresponding to 0 % of span and sets it as the source value.
Press and hold to store the source value as the 0 % value.
Identifies Firmware version. Press and hold
J when powering up.