User Manual
Table Of Contents
- 724 Temperature Calibrator
- Temperature Calibrator
- Introduction
- Contacting Fluke
- Standard Equipment
- Safety Information
- Getting Acquainted with the Calibrator
- Getting Started
- Shut Down Mode
- Contrast Adjustment
- Using Measure Mode
- Using Source Mode
- Setting 0 % and 100 % Output Parameters
- Stepping and Ramping the Output
- Storing and Recalling Setups
- Calibrating a Transmitter
- Testing an Output Device
- Replacing the Batteries
- Replacing the Fuse
- Maintenance
- Specifications
- Index
724
Users Manual
12
Table 4. Key Functions (cont.)
No Name Description
L L
Cycles through :
E
Slow repeating 0 % - 100 % - 0 % ramp
P
Fast repeating 0 % - 100 % - 0 % ramp
N
Repeating 0 % - 100 % - 0 % ramp in 25 % steps
AM
AM
OY
OZ
Disables Shut Down Mode
Enables Shut Down Mode
M XW
Y Z
Increases or decreases the source level.
Cycles through the 2-, 3-, and 4-wire selections.
Moves through the eight memory locations of calibrator setups.
In Contrast Adjustment mode; up-darkens contrast, down-lightens contrast.
N Q
Retrieves a previous calibrator setup from one of eight memory locations.
O S
Saves the calibrator setup to one of eight memory locations. Saves Contrast Adjutment setup.
P
M
Cycles the calibrator through MEASURE and SOURCE modes in the lower display.
Q T
Selects TC (thermocouple) measurement and sourcing function in the lower display. Repeated pushes cycle through
the thermocouple types.
R V
Toggles between voltage, sourcing, and measuring functions in the lower display.
S R
Selects RTD (resistance temperature detector) measurement and sourcing function in lower display. Repeated
pushes cycle through the RTD types.
T U Selects the ohms measurement and sourcing function.