User Manual
Table Of Contents
- 724 Temperature Calibrator
- Temperature Calibrator
- Introduction
- Contacting Fluke
- Standard Equipment
- Safety Information
- Getting Acquainted with the Calibrator
- Getting Started
- Shut Down Mode
- Contrast Adjustment
- Using Measure Mode
- Using Source Mode
- Setting 0 % and 100 % Output Parameters
- Stepping and Ramping the Output
- Storing and Recalling Setups
- Calibrating a Transmitter
- Testing an Output Device
- Replacing the Batteries
- Replacing the Fuse
- Maintenance
- Specifications
- Index
Temperature Calibrator
Using Measure Mode
19
Measuring Electrical Parameters (Lower Display)
To measure the electrical parameters using the lower
display, proceed as follows:
1. Connect the calibrator as shown in Figure 9.
2. If necessary, press
M for MEASURE mode (lower
display)
3. Press
l for dc voltage or current, or U for
resistance.
TC RTD
100%
25%
25%
RECALL
MEAS
SOURCE
STORE
SETUP
0%
TEMPERATURE CALIBRATOR
724
V
LOO P
mA
V
˚
F
˚
C
zi07f.eps
Figure 9. Measuring Electrical Parameters