User Manual
Table Of Contents
- 724 Temperature Calibrator
- Temperature Calibrator
- Introduction
- Contacting Fluke
- Standard Equipment
- Safety Information
- Getting Acquainted with the Calibrator
- Getting Started
- Shut Down Mode
- Contrast Adjustment
- Using Measure Mode
- Using Source Mode
- Setting 0 % and 100 % Output Parameters
- Stepping and Ramping the Output
- Storing and Recalling Setups
- Calibrating a Transmitter
- Testing an Output Device
- Replacing the Batteries
- Replacing the Fuse
- Maintenance
- Specifications
- Index
724
Users Manual
26
Using Source Mode
In SOURCE mode, the calibrator generates calibrated
signals for testing and calibrating process instruments,
supplies voltages and resistances, and simulates the
electrical output of RTD and thermocouple temperature
sensors.
Sourcing Electrical Parameters
Volts or ohms are sourced and shown in the lower
display.
To select an electrical sourcing function, proceed as
follows:
1. Connect the test leads as shown in Figure 12,
depending on the source function.
2. If necessary, press
Mfor SOURCE mode.
3. Press
V for dc voltage, or U for resistance.
4. Enter the desired output value by pressing
X and
W keys. Press Y and Z to select a different digit to
change.
V
mA
MEASURE
SOURCE / MEASURE
30V MAX ALL TERMINALS
4W
3W
V
RTD
TC
COM COM
LOOP
Red
Black
+
–
Common
V
zi09f.eps
Figure 12. Electrical Sourcing Connections