User's Manual
Table Of Contents
- 45 Dual Display Multimeter
- 1. Introduction
- 2. Getting Started
- 3. Operating the Meter From the Front Panel
- 4. Applications
- 5. Operating the Meter Using the Computer Interface
- Introduction
- Preparing the Meter for Operations via the RS-232 Interface
- Preparing the Meter to be Operated via IEEE-488 Interface
- Getting Started With An Installation Test
- How the Meter Processes Input
- How the Meter Processes Output
- Triggering Output
- Service Requests (IEEE-488 Only and Status Registers
- Computer Interface Command Set
- IEEE-488 Capabilities and Common Commands
- Function Commands and Queries
- Function Modifier Commands and Queries
- Range and Measurement Rate Commands and Queries
- Measurement Queries
- Compare Commands and Queries
- Trigger Configuration Commands
- Miscellaneous Commands and Queries
- RS-232 Remote/Local Configurations
- Sample Program Using the RS-232 Computer Interface
- Sample Programs Using the IEEE-488 Computer Interface
- 6. Maintenance
- Appendices
A-1
Appendix A
Specifications
Introduction
Appendix A contains the specifications of the Fluke 45 Dual Display Multimeter.
These specifications assume:
• A 1-year calibration cycle
• An operating temperature of 18 °C to 28 °C (64.4 °F to 82.4 °F)
• Relative humidity not exceeding 90 % (non-condensing) (70 % for 1,000 kΩ
range
Accuracy is expressed as +(percentage of reading + digits).
Display Counts and Reading Rates
Rate Readings per Second Full Range Display Counts
Slow
Medium
Fast
2.5
5
20
99,999*
30,000
3,000
* Ohms full range will typically be 98,000 counts
RS-232 and IEEE-488 Reading Transfer Rates
Reading Per Second
Rate
Internal Trigger
Operation (TRIGGER 1)
Internal Trigger Operation
(TRIGGER 4)
Print Mode Operation
(Print set at 1)
Slow
Medium
Fast
2.5
4.5
4.5
1.5
2.4
3.8
2.5
5.0
13.5
Response Times
Refer to Section 4 for detailed information.