Specifications

LinkRunner AT 1000/2000 Network Auto-Tester
Users Manual
18
Restore Factory Defaults
Restores any configuration changes to the following
LinkRunner AT factory defaults.
• IP Configuration:
IPv4: DHCP
IPv6: Disabled
• VLAN/MAC Configuration:
VLAN: Disabled
VLAN ID: 0
Priority: 0
User Defined MAC: Disabled
MAC Address: Linkrunner MAC address
• AutoTest Configuration:
Continuous Mode: On
Target: none
• PoE Configuration:
Enable PoE: Disabled
Class: Class 1
• Connect Configuration:
802.1x: Disabled
Speed/Duplex: Auto
• General Configuration:
Cable Length Unit, Meters
Auto Shutoff, Enabled
• Set Language:
English
When you Select Restore Factory Defaults, you will be
prompted with a two popup. Select
OK, then press L.
The restore will be completed and the tester will turn off.
Firmware Update
1 Download the LinkRunner firmware update file from
the Fluke Networks website, or contact Fluke Networks
to get the update by other means. Save the file to your
hard disk.
2 Get the latest version of LinkRunner Manager from the
Fluke Networks website.
3 Start LinkRunner Manager on your PC.
4 Turn on the tester.
5 Select Tools > Firmware Update > select  Update.
6 Use the USB cable supplied with the tester to connect
the tester to the PC.