User's Manual

LVD2EU
VoltAlert
Safety Sheet
Read First: Safety Information
WX Warning
To prevent possible electric shock, re, or personal injury:
● Use the Product only as specied, or the protection supplied by the Product
can be compromised.
● Do not use if the ashlight does not operate.
● The battery door must be closed and locked before you operate the Product.
● Measure a known voltage rst to make sure that the Product operates
correctly.
● When using the Product if tip does not glow, voltage could still be present.
The Product indicates active voltage in the presence of electrostatic elds
of sufcient strength generated from the source (MAINS) voltage. If the eld
strength is low, the Product may not provide indication of live voltages. Lack
of an indication occurs if the Product is unable to sense the presence of
voltage which may be inuenced by several factors including, but not limited
to:
• Shielded wire/cables
• Thickness and type of insulation
• Distance from the voltage source
• Fully-isolated users that prevent an effective ground
• Receptacles in recessed sockets/ differences in socket design
• Condition of the Product and Batteries
● Disable the Product if it is damaged.
● Do not use the Product if it is damaged.
● Use Product with arrow visible.
● Hold the Product behind the tactile barrier.
● Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V dc.
● Do not use for dc voltage measurements or around voltages exceeding
600 volts, or in the presence of variable motor drives.
● Use caution with voltages above 30 V ac as a shock hazard may exist.
● Do not allow the Product to directly touch live circuits.
● Using the Product while attached to any metal object could lead to electric
shock or personal injury.
● Do not stare or look directly at the LED ash light. The light is extremely
bright.
● Comply with local and national safety codes. Use personal protective
equipment (approved rubber gloves, face protection, and ame-resistant
clothes) to prevent shock and arc blast injury where hazardous live
conductors are exposed.
● Batteries contain hazardous chemicals that can cause burns or explode. If
exposure to chemicals occurs, clean with water and get medical aid.
● Remove the batteries if the Product is not used for an extended period of time,
or if stored in temperatures above 50 °C. If the batteries are not removed,
battery leakage can damage the Product.
● Do not disassemble or crush battery cells and battery packs.
PN 4572337 September 2014
© 2014 Fluke Corporation. Specications are subject to change without notice.
All rights reserved.
FOR USE BY COMPETENT
PERSONS
Anyone using this instrument should be
knowledgeable and trained about the risks
involved with measuring voltage, especially
in an industrial setting, and the importance of
taking safety precautions and of testing the
instrument before and after using it to ensure
that it is in good working condition.