Musical Instrument User Manual

5 - 66 FUNCTION REFERENCE
REGISTER EMPTY Recalling traces from an empty register is
not possible. Protection of an empty
register is impossible.
Function ’RECALL’.
REGISTER PROTECTED Register cannot be saved in protected
memory location.
Function ’SAVE’.
REGISTER USED FOR MATH Trace cannot be saved in register M1 or
M2, because it is in use for a MATH
function.
Function ’MATHEMATICS’.
SETUP EMPTY Recalling settings from an empty memory
location is not possible. Protection of an
empty front is impossible.
Function ’SETUPS’.
SETUP PROTECTED Settings cannot be saved in protected
memory location.
Function ’SETUPS’.
STD SETUP = RECALL ONLY Save settings in the ’std’ front is not
possible.
Function ’SETUPS’.
TIME/DIV ADJUSTED Set timebase to fastest Roll mode
position.
FOR ROLL Function ’TB MODE’.
TOO MANY TRACES Maximum allowed traces is eight.
SETUPS
Description:
Ten complete front panel settings can be saved into a battery backed-up memory.
This feature is useful for routine measurements. Setups are stored in memory
location labeled s1 .... s10. These memories are accessible under the menu key
SETUPS
. The menu structure is shown in Appendix H.
Selection of the memories s1 ... s10 is done with the TRACK control. Memory
location ’std’ is a factory-stored set of standard settings that can be used to put
the instrument in a defined state. For a detailed specification, refer to the
STANDARD FRONT function.