Musical Instrument User Manual

HOW TO USE THE INSTRUMENT 4 - 49
4.11 MEASUREMENT FUNCTIONS
When operating in the
analog
mode, you can use the cursors to measure
amplitude and time data.
When operating in the
digital
mode, the scope has an extensive set of
fully
automated
amplitude and time measurement functions. You can select two
measurements to be performed simultaneously. These measurements are
updated automatically, so that when signals change, the measured values
automatically changed at the same time. The read- outs are displayed in the
upper section of the screen.
STANDARD SETTING
Start with the standard setting.This ensures a correct start.
- Simultaneously press the STATUS and TEXT OFF keys.
- Connect the Probe Adjust signal to channel 1.
The Probe Adjust signal now supplied to the input is a square wave with a lower
level of 0V and a top level of 600 mV.
-Press AUTOSET.