Datasheet
91
Accessories
For automotive applications
TP81 and TP82
• Stainless steel probe
pierces insulation
on 0.75 mm² to
2.00 mm² wire
• Design provides complete
insulation while working on fuel
injectors or sensors
• TP81 for use with modular test leads
(Fluke TL224)
• TP82 slips over probe tips (Fluke TL71)
• Rated to 60 V dc
TP88 Rigid
Backprobe Pin Set
• 51 mm (2 inch)
long pins pass
between the
weather pack seal and wire
• Use with Fluke TL71 or TL75 test
lead sets
• Rated to 60 V dc
TLK281 Automotive Test Lead Kit
• Insulation piercing probes
• SureGrip™ silicone test leads
• SureGrip test probes
• SureGrip plunger style alligator clips
• SureGrip alligator clips
• Carrying case
TLK282 Deluxe Automotive Test Lead Kit
• Insulation piercing probes
• Set of five automotive back probe pins
• SureGrip silicone test leads
• SureGrip test probes
• SureGrip plunger style alligator clips
• SureGrip alligator clips
• SureGrip hook clips
• Carrying case
80K-6, 80K-15, 80K-40 High Voltage Probes
• Allows a digital multimeter to measure up
to 6,000 volts peak, 15,000 volts peak and
40,000 volts peak respectively
• 1000:1 division ratio output when connected
to 10 MΩ multimeter
• Ground clip included
• Intended for low energy applications that are
referenced to ground
• 80K-15 (not available in Europe)
Note: intended for low energy applications only
High-voltage probes
TP40 Automotive
Back Probe Pin Set
• Set of five 38 mm
(1.5 inch) pins
• Rated to 60 V dc
• Provide an easy
connection past
weather pack seals to
connector conductors
• Use with Fluke TL71 or TL75 test
lead sets
TL82 Automotive
Pin & Socket
Adapter Set
• Collection of male
and female
adapters allows
you to make firm
connection to pin
and socket connectors
• Adapters with flexible tips come
in the following sizes: 0.3 mm² to
3.3 mm²
• Rated to 60 V dc
TL28A Automotive
Test Lead Set
• Flexible silicone
insulated leads
are heat and cold
resistant
• Rated 30 V, 10 A
BP980 Double
Banana Plug Kit
• 5 pair (red, black)
of double 4 mm
banana plugs
• Each plug has
3.1 mm holes for
mounting wires
and components
• Brass plugs/jack, beryllium copper
springs
• 30 V rms or 60 V DC, 15 A
Fluke test leads, probes and clips
The best leads for all your measurement needs