user manual
Table Of Contents
- 45 Dual Display Multimeter
- 1. Introduction
- 2. Getting Started
- 3. Operating the Meter From the Front Panel
- 4. Applications
- 5. Operating the Meter Using the Computer Interface
- Introduction
- Preparing the Meter for Operations via the RS-232 Interface
- Preparing the Meter to be Operated via IEEE-488 Interface
- Getting Started With An Installation Test
- How the Meter Processes Input
- How the Meter Processes Output
- Triggering Output
- Service Requests (IEEE-488 Only and Status Registers
- Computer Interface Command Set
- IEEE-488 Capabilities and Common Commands
- Function Commands and Queries
- Function Modifier Commands and Queries
- Range and Measurement Rate Commands and Queries
- Measurement Queries
- Compare Commands and Queries
- Trigger Configuration Commands
- Miscellaneous Commands and Queries
- RS-232 Remote/Local Configurations
- Sample Program Using the RS-232 Computer Interface
- Sample Programs Using the IEEE-488 Computer Interface
- 6. Maintenance
- Appendices
45
Users Manual
2-4
POWER
AUTO
MN MX
RATE
dB
REL
REF# LOCAL
THRESH ADDR
BAUD
HOLD
LO
HI
COMP
A
A
V
FREQ
V
REF
-Press to Toggle In and Out of Decibels
-Press to Toggle In and Out of Relative Mode
FUNCTION BUTTONS:
-Press to Select a Function
FUNCTION MODIFIER BUTTONS
-Press to Select Touch Hold;
-Press to Force Update;
-Press and Hold Down for 2 Seconds to Exit.
-Press in to Power-Up
-Press to Step Through
Measurement Rate
(Slow, Medium, Fast)
-Press to Select the MN MX Modifier;
-Press to Toggle Between Minimum and Maximum Reading;
-Press and Hold Down for 2 Seconds to Exit MN MX Mode.
2ND
2ND (SHIFT BUTTON):
-Press then a FUNCTION BUTTON to Select Function for
Secondary Display. (Refer to Section 3 for other uses of .)
2ND
RANGE BUTTONS:
-Press to Toggle In and Out of Manual Ranging;
-Press or to Up Range or Down Range
AUTO
2ND
aam04f.eps
Figure 2-4. Summary of Basic Pushbutton Operations