User's Manual

2
component of the product may be damaged
or loosen, resulting product damage.
lIf GPS antenna lead wraps steering column
or gear lever, it is extremely dangerous.
Please make the installation won’t hinder
driving.
lPlease make sure all leads won’t be hooked
by car door or sliding mechanism of the
seats, for avoiding short circuit.
lTo prevent from electromagnetic
interference, please put other cables or
leads away from the FM, AM antenna and
their leads, GPS antenna and its lead. You
should arrange the above-mentioned leads
separated each other. DO NOT bind up the
leads or cross them, otherwise,
electromagnetic interference may be
intensified, leading to incorrect positioning
or error display.
lAfter finishing navigation system
installation, examine and confirm other
devices of the vehicles are correctly
connected.
Welcome
System Installation
Thank you for using our multimedia vehicle
navigation system, we sincerely provide with
excellent quality and superb experience to
you.
1. Installation key points
l
l
l
l
This product is used for vehicles with 12V
storage battery and negative ground end.
Before installation, please check out the
voltage in storage battery.
To avoid system short circuit, it is
recommended to dismantle the negative
wire of the battery.
DO NOT directly connect this product to
storage battery by over passing fuse.
DO NOT directly connect the power cable
of this product to the power cable of other
electric appliances.
Before using the system
Before using the system
2. Mainframe installation
Don’t damage or stain the
panel.
l
l
l
Caution:
3. GPS antenna installation
Firstly take out the original mainframe.
Dismantle the bracket and screws, and then
preserve them. Use connection cable to
finish connection.
Lastly, put the mainframe in place, and use
the original installing screws to fasten the
mainframe.
Before using binding tape to fasten the

GPS antenna, please be sure to use proper
3
cleanse the adhering area. After cleansing,
tear down the back paper, place the GPS
antenna at a proper place, and press it tight
with strength.
Dismantle the side panel, take the cable
through storage box, to the mainframe at
central control platform. Please bind up the
cable with the original cables. 
Connect the GPS antenna port with the
mainframe.
Please make sure all devices are
installed at safe places. If user ’s vehicle
is installed with other devices, please
make sure such installation won’t
interfere with its function.
lBefore installation, please read through
all instructions. It is advised to ask auto
Hi-Fi professional dealer to install this
machine.


Caution:
l