Users Manual

Step 4: Install Handlebars
A. Using the provided 4mm allen wrench, loosen the two stem clamp bolts.
B. Place the center of the handlebar in between the stem clamps. Tighten both bolts by hand making
sure the handlebar can still freely rotate. Check to see that the cables are not twisted around the stem.
C. Rotate the plastic wire harness to the position depicted below. Make sure both cable bundles are fed
through the hooks under the plastic housing.
D. Rotate the handlebar until the preferred position is achieved checking to ensure the handlebar is
centered left-to-right within the stem clamp.
E. Evenly tighten the bolts to 6 to 8 Nm using a torque wrench.
F. Ensure the gap between the stem and clamp is even.
Note: Complete assembly of the bike per the steps above. The stem and handlebar angle can be
adjusted as needed based on rider preference. Always re-tighten bolts to the specified torque values
prior to riding.
A
F
E
C
B
D