User's Manual

User Manual

Product Information

Safety and Compliance Information

Using Your Device Around Other Electronic Devices

The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its

instructions, may cause interference to radio communications and electronic equipment. External RF

signals may affect improperly installed or inadequately shielded electronic operating systems,

entertainment systems, and personal medical devices.

While most modern electronic equipment is shielded from external RF signals, if in doubt, check with

the manufacturer. For personal medical devices (such as pacemakers and hearing aids), consult with

your physician or the manufacturer to determine if they are adequately shielded from external RF

signals.

There are some places where RF signals could constitute a hazard, such as health care facilities, and

construction sites. If you are not sure, look around for signs indicating that two-way radios or mobile

phones should be turned off.

FCC Compliance Information

Radio Frequency Information

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications that are not expressly approved by the party responsible for compliance could

make the device no longer comply with the FCC Rules.

Information on your device is on file with the FCC and can be found by inputting your device’s FCC ID,

which can be found on the back of Device, into the FCC ID Search form available at

transition.fcc.gov/oet/ea/fccid.

PAGE 1
User Manual Product Information Safety and Compliance Information Using Your Device Around Other Electronic Devices The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its instructions, may cause interference to radio communications and electronic equipment. External RF signals may affect improperly installed or inadequately shielded electronic operating systems, entertainment systems, and personal medical devices.
PAGE 2
Radio frequency exposure The device has been tested and meets applicable limits for radio frequency (RF) exposure. Recycling Product Properly In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of or recycle the Products in accordance with your local laws and regulations. For information about recycling the Products, go to www.amazon.com/devicesupport. Product Specifications Model Number: S7RN5S Power: 5.25VDC 1.