User's Manual

Page
18
of
68
Step 3.After the second person answers the call, press conf softkey button to start the conference call; all three parties will be participating in a
conference call.
Note: If you hang up firstly, the other two parties will be disconnected; if one party hangs up firstly, you can go on talking with the other party.
5.8 Attended Transfer
Y ou call the person to whom you are transferrin g the call and speak to them before transferring the call:
Step 1.To initiate a transfer; press the HOLD button during an active call. This places the first call on hold and you will hear a dial tone.
Step 2.Dial the second person’s telephone number.
Step 3.When the second person answers, you can have a private conversation with the second person without the first person hearing it.
Step 4.To connect the call to the second person, press the xfer softkey button to complete the transfer. You will be disconnected from the call.
Step 5.If you hang up during the call with the second person before pressing xfer softkey button, the transfer is not completed; this only ends the
call with the second person, and you can press the HOLD button to continue the first call.
5.9 Unattended Transfer
You can transfer an active call to a third party without announcement.
Step 1.To initiate an unattended (blind) transfer; press the xfer softkey button during an active call. The first call is placed on hold and you will
hear a dial tone.
Step 2.Now dial the second person’s telephone number with immediately ending char “#”, IP622C/IP622CWP will transfer phone automatically
and you will be disconnected from the call.
5.10 Forwarding Calls
You can forward all calls, forward calls when the phone is busy or forward calls when there is no answer.
Below are the steps to configure call forward from menu. You can also set call forwarding options from your PC using the IP Phone Web
Interface.