User's Manual

Page
3
of
68
Notice: If the phone does not provide this screen, re-confirm installation and connections. If these are incorrect, try unplugging the
phone and plugging it back in again. If you still don’t see the display, then contact your Phone Administrator or service provider.
2.4 Connect to the Internet
You can connect the FIP11/FIP11W/FIP11WL to the Internet via wired and via wireless.
2.4.1 Via Wired
Step 1.Check FIP11/FIP11W/FIP11WL have powered on correctly.
Step 2.Plug the Ethernet cable into Internet port in the rear side of the base station. Plug the other end of the Ethernet cable into your already prepared network connection.
Step 3.After the sequence, the IP Address of Internet port will appear at the bottom of the LCD.
2.4.2 Via Wireless (Only for IP622CWP)
You can configuration wireless from LCD menu and from webpage.
From LCD menu:
Step 1.Press the button, and then select 13Wireless using the UP and DOWN button.
Step 2.Choose 2Wireless Connection and you can view the wireless then FIP11/FIP11W/FIP11WL can connect to.
Step 3.Highlight one network using the UP and DOWN button, and press the softkey button under link to connect.
Note: If the Wi-Fi need authentication, choose the authentication and fill in the password.
Step 4.Press the softkey button under ok to confirm connecting.
Step 5.If the AP has connected, the
wireless icon in LCD will display linked.
From webpage:
Step 1.Login the web and then open
Network/Wireless webpage.
Step 2.Highlight one Wi-Fi and the
words will get larger, following is one
example: