User's Manual

Page
63
of
68
Solution:
Factory default: press Menu button and choose 16Factory Default, then a notice will appear, choose OK by using the corresponding softkey
button. And this way is required password,too.
There is another way to make factory default, press #*06# on the phone's panel, and then select 4 Factory Reset, input YES(937) to confirm
your action, and then the phone will reset all the settings.
If you choose factory default, you will return the phone to the original factory settings and will erase ALL current settings, including the
directory and call logs.
8.9 FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.