TIO A M R N FO N I ANT T R e nce O s e P r u e f e M I efor uture re b d a Re or f f n i ta & re For all customer enquiries or for replacement parts, contact:- 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Carton Contents switchbox start/stop levers cable clip pack of 10 bags bolt washer upper handle handle knobs cable clip electric cable with moulded plug nuts washer pin bolt retaining clips lower handle cutting height spacers (1 fitted to lawnmower & 2 in loose parts pack pin instruction manual spanner/scraper tool IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
. Do not use the lawnmower if the electric cables are damaged or worn 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower. 6.
Assembly Instructions B A 1 2 1 3 Lower Handle Assembly (A) 1. Lift the grassbox lid and remove the grassbox. 2. Insert the lower handle into the handle slots, ensuring that the holes are aligned. 3. Insert the pins and secure with the retaining clips (A1). 4. Replace the grassbox, and lower the grassbox lid carefully. Upper Handle Assembly (B) 1. Insert the nut into the handle knob (B1). 2. Align the holes in the upper and lower handles and secure with the bolt, washer and wing knob (B2). 3.
How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection. Do Not Overload Your Mower Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage.
Caring for your Lawnmower Cleaning IMPORTANT: It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES. Switch off and remove the plug from the mains before cleaning. It is recommended that you clean your lawnmower straight after mowing while the grass is still wet. 1. Remove grass from under the hood with the spanner/scraper tool. (Q1) 2.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.
EC Declaration of Conformity I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham. DL5 6UP. Certify that the product:Category........ Electric Hover Make.............. Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham.