IO T A RM N NFO I T TA N se R O ence r P u e f e M e r I efo re r b u t d u a f Re n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
1 Carton Contents trigger adjustable handle 2 handle knobs adjustable shoulder harness mode indicator 2 handle bolts Air inlets debris bag frame cutting lines debris bag instruction manual nozzle IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
2 3. Do not use the product if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your electric cable must be uncoiled, coiled cables can overheat and reduce the efficiency of the product. 6. Do not pull cable around sharp objects. 7.
3 Assembly Instructions C A B D To Attach Debris Bag to Bag Frame With bag frame on the ground:1. Fit first two holes on the plastic trim of the debris bag to the first two location points on the front of the bag frame (where debris fin is attached). (A) 2. Fit next hole on the plastic trim to next location point on bag frame. (B) 3. ...until all holes on the plastic trim of the debris bag are securely located to bag frame. (C) • ENSURE THE DEBRIS BAG IS FITTED SECURELY TO THE BAG FRAME.
4 G Assembly instructions H Fitting the Handle Bolt (G) 1. Place handle bolt into the location slot on the product and slide into place.(G). 2. Repeat on the other side. Fitting the Handle (H) 1. Locate handle onto handle bolts on each side of the product. 2. Secure handle by turning handle knobs clockwise. (H) 3. The handle can be adjusted by turning handle knobs 3 full turns anti-clockwise, moving handle to position required and re-securing handle as described in 2.
5 How to Use Con’t JET VACUUM N Position 3 - Jet Vacuum Mode This position is intended to be used to collect debris which is damp or stubborn. It directs a small jet of air towards the ground which will loosen stubborn material. Using As A Jet Vacuum 1. Select position 3 on the mode indicator. See fig N. 2. Position the nozzle above and slightly forward of the debris and squeeze the trigger. 3. Slowly move the nozzle back over the debris. This allows a jet of air to lift the debris from the ground. 4.
6 Fault Finding Hints Fails To Operate 1. Is the power turned on? 2. Is the fully assembled debris bag correctly fitted to the product? 3. Check the fuse in the plug, if blown replace. 4. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor Poor Blowing 1. The air inlets are blocked, clean all air inlets. 2. Mode indicator not in the right position? 3.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.