Hover Vac IO T A RM N NFO I T TA N se R O ence r P u e f e M e r I befo future r d a e R n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 0870 609 1901 www.flymo.com customer.services@husqvarna.co.
Carton Contents switchbox start/stop lever cable clip upper handle washers bolt handle knob bolt nut cable clip electric cable with moulded on plug handle knob lower handle fixing pin fixing pin instruction manual plastic cutters IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your product. 6. Keep cable away from product, always work away from the power point using up and down, never in circles. 7. Do not pull cable around sharp objects.
Assembly Instructions A Assembly of lower handle to hood (A) 1. Place the ends of the lower handle into the slots 2. Secure lower handle to hood by firmly pushing fixing pin through holes in hood and handle (A1). 3. Repeat on the other side. • NOTE Should a problem occur when securing handle with the fixing pin, carefully lever the pin out of location and repeat steps 1 to 3 above. 1 B lock-off button handle knob nut washer C bolt Fitting Upper Handles to Lower Handles (B) 1.
Adjusting the Cutting Height HIGHEST This symbol visible J LOWEST This symbol visible K L 1 • • THERE ARE 2 CUTTING HEIGHTS (J & K) Height of cut is adjusted by turning over the cutting head. • Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down. • To Remove the Cutting Head and Fan (L) Hold the fan firmly and twist the cutting head anticlockwise as illustrated.
Grassbox • For optimum performance your product is designed to be used with the grassbox fitted. Grassbox full Indicator (P) • IMPORTANT The machine must be switched on for the grassbox full indicator to operate. 1. When the ball reaches the top of the indicator window, it is time to empty the grassbox. See figure N. 2. When the ball is NOT visible in the indicator window, grass is being collected. See figure N.
• Caring W It is very important that you keep your product clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. Cleaning (W) • USE GLOVES 1. Remove grass from under the hood with a piece of wood or similar. 2. Using a soft brush - remove grass clippings from all air intakes, the roller, grassbox and grassbox lid. 3. Remove the cutting head, see Figure L, to gain access to the fan and clean with a soft brush. 4.
Environmental Information Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life. • Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.