HT42/420 HT45/450 HT51/510 HT60/600 TIO A M R N NFO I T N RTA use nce O e r P e f e I M befor re re u t d u a f Re for n i a t & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
1 Carton Contents Switch levers Handguard instruction manual blade cover/storage holder IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product.
2 General 1. Never allow children or people unfamiliar with these instructions to use the Hedgetrimmer. Local regulations may restrict the age of the operator. 2. Only use the Hedgetrimmer in the manner and for the functions described in these instructions. 3. Never operate the Hedgetrimmer when you are tired, ill or under the influence of alcohol, drugs or medicine. 4. The operator or user is responsible for accidents or hazards occurring to other people or their property. Electrical 1.
3 CABLES IMPORTANT • Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating : 1.00mm2 size cable, 10 amps 250 volts AC. • YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Mains Cables and Extension Cables are available from your local Electrolux Outdoor Products Approved Service Centre. 2. Do not wire an extension cable directly to your product yourself.
4 Starting and Stopping Before starting your Hedgetrimmer. B 1. Form a loop in mains cable and push the loop through the hole in the handle as illustrated in Fig. B. 2. To secure, position the loop over the hook and pull back as illustrated in Fig. C. 3. Connect to mains and switch on 4. Remove blade cover/storage holder as illustrated in Fig. D. C D To start your Hedgetrimmer 1. There are two switch levers fitted to your Hedgetrimmer. 2.
5 Caring for your Hedgetrimmer J Cleaning (J) 1. Using a soft brush - remove debris from all air intakes and cutting blade. 2. Wipe over surface of your hedgetrimmer with a dry cloth. • IMPORTANT Never use water for cleaning your hedgetrimmer. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts. K Lubricating the Cutting Blade For easier operation and longer life, lubricate the cutter blades before and after use.
6 Fault Finding Hints Fails to Operate 1. Is the Power Turned On? 2. Check the fuse in the plug, if blown replace. 3. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Cutting blade stops under load 1. Cut at a slower pace. 2. If cutting blade still stops under load? Disconnect from the mains electricity supply and consult your local approved Service Centre. Fails to stop when one switch lever is released.
Service Recommendations 1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Electrolux Spare Parts. 3. Prepacked spares are available from most Electrolux Outdoor Products stockists. 4. Your product is uniquely identified by a silver and black product rating label 5.