33cm TIO RMA N NFO I T TA N se R nce O e r P u e f e M I efor uture re b d a Re or f f n i ta & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 eop.customer.services@electrolux.co.
1 Carton Contents start/stop lever upper handle lock off button switchbox cable restraint locking ring screw locking ring cable clip x 2 electric cable with moulded on plug nut x 2 (if applicable) bolt x 2 upper handle knob x 2 lower handles (x 2) washer x 2 (M6) grassbox handle washer x 2 (M8) safety flap grassbox upper nut x 2 (M8) lower handle knob (x 2) motor cover grassbox lower deck instruction manual spanner Safety If not used properly this lawnmower can be dangerous! This lawnmower
2 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower. 6. Keep cable away from lawnmower, always work away from the power point mowing up and down, never in circles. 7.
3 Assembly Instructions A Assembly of Lower Handles to Deck 1. Insert the nuts into the wing knobs. (A1) 2. Place the hole in the lower handle over the end of the tie rod (A) 3. Place the washer and wing knob onto the end of the tie rod and firmly tighten. (A) 4. Repeat on the other side. 1 B C Assembly of Cable Restraint 1.
4 Cutting Height Adjustment J Cutting Height Adjustment (J) & (K) • Height of cut is adjusted by raising or lowering the wheels. • There are five heights of cut on this product. • HEIGHT OF CUT Low WHEELS POSITION Front position 1 Back position 1 Low to Medium Front position 1 Back position 2 Medium Front position 2 Back position 2 Medium to High Front position 2 Back position 3 High Front position 3 Back position 3 K 1 NOTE A medium height of cut is recommended for most lawns.
5 Starting and Stopping M N P 1 To Start your Lawnmower 1. Form loop in mains cable and push the loop through the slot in the cable restraint (M) 2. To secure, position loop over the hook and pull the cable back through the slot (N). 3. Connect plug to mains and switch on. 4. Tilt the handle downwards to slightly raise the front of the lawnmower and to reduce the risk of lawn damage whilst starting. The switchbox is provided with a lock-off button (P1) to prevent accidental starting. 5.
6 Caring for your Lawnmower V Cleaning (V) • USE GLOVES • IMPORTANT It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. 2. Using a soft brush - remove grass clippings from all air intakes, the discharge chute and the grass box. 3. Remove the blade, see Figure T, to gain access to the fan and clean with a soft brush. 4.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.
