TIO A M R N NFO I T TA N se R O ence I M P before u re refer tu Read in for fu ta & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
1 Carton Contents NonHeight Adjust Height Adjust Nut (if applicable) Handle Knob Bolt Steady Handle Bolt Nut (if applicable) Steady Handle Handle Knob Scraper Tool (Multi-Trim 200 only) Guard Guard Instruction Manual Instruction Manual Electric Cable with moulded on plug Electric Cable with moulded on plug IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
2 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your trimmer. 6. Keep the cable clear of the cutting area and obstacles at all times. 7. Do not pull cable around sharp objects. 8.
3 Assembly Instructions A 3 1 2 B D 4 C E handle knob nut (if applicable) Safety Guard Assembly (A), (B) & (C) • If you have a Multi Trim 200 your safety guard will be fitted with a wire guard as shown in figure J2. 1. Align the arrow on the top of the safety guard (A1) with the arrow on the side of the trimmer (A2). 2. Locate the safety guard (A3) over the cutting head (A4). Ensure the nylon line is fed through the hole in the safety guard as illustrated in fig A.
4 How to Trim and Edge WARNING: The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer. Overloading can be avoided by making sure the motor speed does not drop unduly. Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
5 Manual Line Feed S 1 Line manual line feed button To manually feed the nylon line (S) 1. If required line can be fed out manually. 2. To operate, press and release manual line feed button, whilst gently pulling on the line until it reaches the line cutter. (If 2 lines are fitted do this to one line only, then gently pull on the second line, there is no need to press the manual line feed button again). 3. If the line extends past the line cutter, too much line has been fed out. 4.
6 Spool Cap and Nylon Line (2 Lines) cont. To replace nylon line. For your convenience it is recommended you buy spool and line complete. Nylon line only is also available. Both are available from Electrolux Outdoor Products stockists. To fit spool and line complete: 1. Remove the cap. 2. Remove old spool. 3. Place spool into spoolholder. 4. Release one line from cleat. 5. Secure line into slot (U1). 6. Repeat for second line.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.
