Mow n Vac IO T A RM N NFO I T TA N se R O ence r P u e f e M e r I befo future r d a e R n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Carton Contents switch handle upper wing knob bolt M6 nut washer cable clip joint handle tube screw M5 nut square headed bolt lower wing knob cable clip M6 nut washer lower handle fixing pin electric cable with moulded on plug instruction manual plastic cutters IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your product. 6. Keep cable away from product, always work away from the power point using up and down, never in circles. 7. Do not pull cable around sharp objects.
Assembly Instructions A 1 2 B Assembly of lower handle to hood (A) 1. Place the ends of the lower handle into the slots ensuring that the joint is facing the correct way (A1). 2. Secure lower handle to hood by firmly pushing fixing pin through holes in hood and handle (A2). 3. Repeat on the other side. • NOTE Should a problem occur when securing handle with the fixing pin, carefully lever the pin out of location and repeat steps 1 to 3 above. Assembly of handle tube to joint (B) 1.
Adjusting the Cutting Height HIGHEST This symbol visible F LOWEST This symbol visible G H • • THERE ARE 2 CUTTING HEIGHTS (F & G) Height of cut is adjusted by turning over the cutting head. • Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down. • To Remove the Cutting Head and Fan (H) Hold the fan firmly and twist the cutting head anticlockwise as illustrated. Hold the cutting head in the centre and remove as illustrated.
Grassbox • For optimum performance your product is designed to be used with the grassbox fitted. L Emptying the Grassbox (L) • Stop the product and wait until the cutting head has stopped rotating before emptying the grassbox. 1. Remove the grassbox lid. 2. Lift the grassbox off the product and empty. 3. Replace grassbox and lid carefully. • Failure to fit the grassbox and lid correctly will cause poor collection of grass clippings.
• Caring R It is very important that you keep your product clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. Cleaning (R) • USE GLOVES 1. Remove grass from under the hood with a piece of wood or similar. 2. Using a soft brush - remove grass clippings from all air intakes, the roller, grassbox and grassbox lid. 3. Remove the cutting head, see Figure H, to gain access to the fan and clean with a soft brush. 4.
Service Recommendations 1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Flymo Spare Parts. 3. Prepacked spares are available from most Electrolux Outdoor Products stockists. 4. Your product is uniquely identified by a silver and black product rating label 5.
EC Declaration of Conformity I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham. DL5 6UP Certify that the Product:Category........ Electric Lawn Trimmer Make.............. Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham.