TIO A M R NFO I T TA N se R O ence I M P before u re refer tu Read in for fu ta & re N
1 Carton Contents handle knob Integrated battery charger handle bolt wall bracket nut (if applicable) steady handle screws guard shoulder harness fixing plugs scraper tool instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
2 10. Do not charge the battery or use the unit in an explosive or corrosive environment. Avoid areas where flammable liquids or gases are present to avoid creating a fire or explosion. 11. Do not attempt to repair the unit including the battery. Nylon line replacement and cleaning the unit are the only items suitable for user maintenance. 12. Do not insert any object into the motor area. Keep free of debris to avoid overheating. 13. Do not incinerate or mutilate the battery.
3 Assembly Instructions cont’ B C D E Fitting the Handle (D & E) 1. Insert the nut into the handle knob. (if applicable) 2. Attach steady handle to product using bolt and handle knob as shown in Fig D. 3. Adjust the steady handle to a comfortable operating position, see Fig E., by unscrewing the handle knob, springing the side lugs apart, moving the handle to the required position, carefully re-engaging the teeth and then tightening the handle knob. Fitting the Shoulder Harness (F) 1.
4 Adjustment J K height adjust knob To adjust the handle length (J & K) 1. Loosen the height adjust knob. (fig J) 2. Adjust length of the handle to the most comfortable operating position (fig K). 3. Re-tighten the height adjust knob. Auto Line Feed System 1. A short length of new line is fed out every time you switch on, this is caused by the cutting head accelerating up to its full speed. 2. To feed more line, it is necessary to switch-off, allow the motor to stop and then restart.
5 Fault Finding Chart WARNING Avoid accidental starting, keep hands and fingers away from the switch lever whilst attempting any maintenance or adjustment. FAULT CHECK LINE NOT FEEDING OR LINE TOO SHORT OR TRIMMER VIBRATES Is the automatic line feed working? CONTINUOUS CLATTERING NOISE No Is the line fed out and visible? No Remove cap and spool, free line and re-fit spool and cap. SEE “SPOOL CAP AND NYLON LINE” Is the manual line feed working? No The line may be jammed on the spool.
6 Spool cap and nylon line cont’ To replace nylon line. Replacement nylon line is available from most Electrolux Outdoor Products stockists. You can buy it either as spool and line complete, or as nylon line only. To replace spool and line (complete) 1. Unwind approximately 100mm of line and feed this through eyelet, see fig X, then drop the spool into spoolholder smooth side uppermost. To replace nylon line on spool. 1. Take line and insert into hole in spool. 2.
Service Recommendations 1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Flymo Spare Parts. 3. Prepacked spares are available from most Electrolux Outdoor Products stockists. 4. Your product is uniquely identified by a silver and black product rating label. 5.