TIO A M R N NFO I T TA N se R nce O e r P u e f e I M befor re re u t d u a f Re for n i a t & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Safety Please Note:- This manual covers various products. Please read the user instructions carefully to fully identify, assemble and use the features that apply to your product. If not used properly this lawnmower can be dangerous! This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower.
16. Remove the plug from the mains : before leaving the mower unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition.; if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. Maintenance and storage 1.
Upper Handle Assembly E D 1 Venturer 370 RE420/420c Fitting Upper Handles to Lower Handles (D & E) 1. Ensure the upper handle is located correctly with the lock-off button on the switchbox uppermost 2. Ensure the upper handle and the lower handle are aligned correctly. 3. Insert the nut into the handle knob. (if applicable) (D1) 4. Fit the bolts, washers and handle knobs. 5. Fit the cable to the handles with the clips provided. Make sure the cable is not trapped between the handles.
Cutting Height Adjustment L1 Wheel removal L2 Wheel removal Cutting Height with removal of wheels (L1, L2, L3) L3 Wheel removal M1 If your lawnmower has wheel hubs as illustrated in Fig L1, the height of cut is adjusted by following steps L1 - L3. Levers fitted 3 1. Remove the wheel by turning the wheel hub in an anticlockwise direction (L1) and relocate in new hole (L2) turning the wheel hub in a clockwise direction to tighten (L3). Repeat for other wheels adjusting to the same position.
How to Mow 1. Start mowing the edge of the lawn nearest to the power point so that the cable is laid out on the lawn you have already cut (T). 2. Mow twice a week in the growing season, your lawn will suffer if more that one third of its length is cut at one time and this may also result in poor collection.
Fault Finding Hints Fails to Operate 1. Is the correct Starting procedure being followed? See ‘To Start your Lawnmower’. 2. Is the Power Turned On? 3. Check the fuse in the plug, if blown replace. 4. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Electrolux Outdoor Products Service Centre. Poor Grass Collection 1. Disconnect from the mains electricity supply. 2.
Service Recommendations 1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Flymo Spare Parts. 3. Prepacked spares are available from most Electrolux Outdoor Products stockists. 4. Your product is uniquely identified by a silver and black product rating label 5.
