Installation Guide

ManualsBrandsFlynamama ManualsKitchenSingle Hole Single-Handle Pull-Down Sprayer Kitchen Faucet in Chrome

1 、 Installation Environment

Product installation diagram

1 、 Installation Environment ----------------------------------- 1

2 、Installation of auxiliary tools --------------------------------- 1

3 、 Verify the quantity of accessories ----------------------------- 2

4 、 Installation size ----------------------------------------- 3

5 、 Installation method--------------------------------------- 4

6 、Method of using ---------------------------------------- 6

7 、Test method ------------------------------------------ 7

8 、Cleaning Care ----------------------------------------- 7

9 、Precautions ------------------------------------------- 8

10、Product Warranty Card ------------

---------------------- 9

2 、Installation of auxiliary tools

hammer level

Glue (do not use glue containing acetic acid)

Impact drill Screwdriver

1、1.Before installation, confirm that the inlet pipe and angle valve are properly install

ed and have been flushed to ensure that there is no impurity in the inlet pipe.

2、 The size of the faucet and the faucet mounting hole are matched.

3、Inlet water pressure requirement: 0. 0 5 M P a ≤ inlet pressure ≤ 0. 7 5 M P a.

4、water temperature requirements: 4 ℃- 90 ℃ (faucet products are suitable for u

se in the building's hot and cold water supply pipeline, the medium temperature

is not more than 90 ℃; can not be used in other fluid environments other than w

ater or other uses; Note that the product or parts are damaged due to low ambie

nt temperature ( under 4 ℃) or excessive ambient temperature (above 90 ℃).

5、If the customer goes out for a long time or does not use the faucet for a long time,

please close the faucet main valve first and open the faucet switch and release th

e pressure and water in the faucet.

adjustable wrench

Summary of content (4 pages)

PAGE 1
、 Installation Environment Product installation diagram 1 、 Installation Environment ----------------------------------- 1 2 、 Installation of auxiliary tools --------------------------------- 1 3 、 Verify the quantity of accessories ----------------------------- 2 1、1.Before installation, confirm that the inlet pipe and angle valve are properly install ed and have been flushed to ensure that there is no impurity in the inlet pipe.
PAGE 2
3 、 Verify the quantity of accessories 4 、 Installation size 8、 shower hose 7、hand held shower 6、faucet body 5、flat washer 4、flat pad 3、lock nut 2、screw 10、water inlet 1、shot 9、water inlet Parts List No. quantity No. quantity No. quantity No. quantity No.
PAGE 3
5 、 Installation method 5 、 Installation method Min.680mm 4 3 1、Open the triangular valve and rinse th e deposit inside the pipeSediment, im purities, when close the triangle valve after the water flow is clean. 2、Install the faucet at the sink opening as shown. 4、Install the shots in steps 1, 2, 3, and 4 as shown in the figure (the lower end of the shot should be greater than or equal to 680 mm). 3、Find the corresponding part according to the accessory drawing as shown in the figure.
PAGE 4
6 、 Method of using 7 、 Test method 1、Turn the faucet handle to the closed position, open the inlet valve, and check all inl et connections for leaks. 2、Open the faucet handle to the maximum and open the inlet valve to check for leaks in the outlet and hose connection. 3、If the water pressure is lower than 0.05MPA (the phenomenon that dripping water may appear in the faucet), a booster pump should be added to the pipeline. 8 、 Cleaning Care �� A、The hand shower is as shown above.