User's Manual

12
FS-lT4S
Digital proportional radio control system
4.4 Adjusting Wheel Position
The position of the wheel can be adjusted to be more comfortable to use.
1. Hold the transmitters handle firmly.
2. Grab the plastic underneath the wheel. (Do not pull the wheel itself as this could lead to long term
wear and damage).
3. Rotate the wheel out and away from you to the desired position (Note: the max rotation is about 45° ,
attempting to push beyond the max rotation can cause damage to the transmitter).
Default Position Fully Extended
4.5 Adjusting Wheel Position Stiffness
It is possible to adjust the stiffness so that the position of the wheel is easier or harder to move. To do this
locate the allen head screw located below the mechanism, and use an allen key to change the stiffness
(Clockwise to tigten).
4.6 Trims
Trims allow you to change the centre point of the steering, throttle, channel 3 and 4. An good example of
this feature would be a model that always turns slightly left, in this case the steering trim can be used to
correct the problem.
The System has 3 trim switches located behind the steering wheel.
4.7 Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver from the battery. (Do not power off you're transmitter until the receiver has
been powerd off, as this may lead to loss of control. )
2. Slide the power switch of the transmitter down to the OFF position.
Danger
• Make sure to disconnect the receiver battery before turning off the transmitter.
Or it may lead to unintended operation and cause an accident.