User's Manual

22
FS-lT4S
Digital proportional radio control system
7 Throttle Middle
This function changes the midpoint of the throttle, this could be used in a
middle in which the servo and the throttle position do not line up with no
throttle, if this is the case the model may move as soon as it’s turned on.
To change the midpoint, use the wheel at the bottom of the screen, the
current position will be shown on the screen in real time.
7.1 Throttle Idel Up
This function is used for models that use a fuel based engine, if left at 0
throttle these engines will stall. To combat this idle up makes sure that the
engine always has some throttle in order to keep it from stalling. When
finished using this mode, you can press the assigned button to bring the
throttle to 0, effectively cutting the engine although this is usually done
using the engine cut function.
This function must be assigned to a switch/button in order to be activated
(see keys function).
To set this function first assigned it to a switch/button, once the button
is pressed the icon in the bottom left corner of the screen (within the
function) should become a tick. Then use the wheel at the bottom of the
screen to change the value.
7.2 Engine Cut
Throttle cut is used for fuel based models and is used to cut the throttle, essentially cutting the engine.
To edit the settings move the wheel at the bottom of the screen. When active the function will stop the
throttle droping below the defined point. For help setting up your model's engine consult the model's
user manual.
This function must be assigned to a switch/button to be activated.