User's Manual

27
8.0 RX Setup
8.1 Bind with a receiver
This function enables you to bind the RX and TX so that no other system may interfere with your models
operation.
To bind the transmitter with a receiver:
1. Connect the bind cable to the RX, then connect the power.
2. On the TX select “Bind with a receiver”.
3. Once the RX and TX are bound the TX will exit this menu automatically (Unless using a 1-way
communication protocol such as AFHDS 2A 1-way in which case you must exit this menu manually).
8.2 RF std.: ADHDS 2A 2-way
This menu allows you to change the communication protocol for the TX,
the available protocols are:
□ AFHDS
□ AFHDS 2
□ AFHDS 2A 1-Way
□ AFHDS 2A 2-Way
Note
AFHDS 2A 2-Way is the latest, most stable and advanced communication
protocol.
When changing mode you will be prompted to confirm.
8.3 Receiver PPM Output
When checked, the receiver only outputs PPM on CH1 output, however PPM is capable of transferring all
channels even though there is only one physical output (When enabled the other 9 outputs are disabled).
To enable PPM touch the box in this menu. When the box is checked the PPM is active.